This is command-line based and much faster than the Windows GUI, but requires compiling source code.
: Ensure you are using the correct USB port on the device (refer to your device's documentation) and that the CP210x USB to UART Bridge drivers are installed. amlogic usb burning tool
| Error Message | Likely Cause | Solution | |---------------|--------------|----------| | [0x10105002] Romcode/Switch status/Identify/Error result | Wrong firmware or incompatible bootloader | Find the correct firmware for your . | | [0x32030201]] Uboot/Get result/DiskInitial error | eMMC problem or wrong erase settings | Try unchecking “Erase Bootloader” or re-flash with “Force Erase All”. | | Device disconnects mid-flash | Bad USB cable or unstable power | Use a high-quality, short USB-A to USB-A cable. Some devices need external power plugged in. | | [0x10302001]] Romcode/Switch status/Check connect/Enum failed | Driver not loaded | Reinstall the WorldCup driver manually via Device Manager. | | Tool doesn’t detect device | Wrong USB port or reset button not held | Try all USB ports. For boxes without a reset button, short the NAND pins (advanced). | This is command-line based and much faster than